Flossing is one of those things that people should do, but most somehow find an excuse not to. Actually, there is good reason not to floss. It's a real pain. If you think about it, flossing the front part of your mouth is easy and does not pose any difficulty. It is the rear area of the mouth that poses the challenge and is the toughest part to reach.

The rear teeth are difficult to reach because the fingers have to extend further into the mouth.It's easy to put your index finger on the cheek side and touch your rear tooth. Putting your index finger in the middle of your mouth (tongue part), to touch the rear tooth, is more difficult because your front teeth are almost touching your knuckles. To put the fingers of both hands in your mouth at the same time, as required in flossing, is very difficult; your jaw can only expand so far and your mouth can only stretch so far.

FLOSSING:: THE RIGHT WAY

Take a piece of floss (12-18 inches), and wind it around the index finger of each hand.

Grasp floss firmly between the thumb and index finger arriving at the flossing position.The fingers are separated by about an inch

Use the thumbs to guide the floss between the upper teeth and use the index fingers to direct the floss between the lower teeth.

Using a gentle sawing motion, guide the floss between your teeth. Never snap the floss into the gums.

Curve floss around the tooth.Gently slide the floss up and down the side of the tooth and under gumline.

Advance floss, after cleaning each side of tooth, by wrapping the floss around the finger of one hand, and unwrapping it on the other. Assume the flossing position,and continue to floss the side of each tooth until done.

There are only 3 brands of floss available in India: Johnson & Johnson-the oldest
Colgate Floss & tape
Oral B-a late entrant which gives more variety & flavours.

The two most important aspects of flossing are: wrapping the floss around the tooth and using a new section of floss for each contact. Wrapping allows the floss to go below the gumline, to remove plaque in areas that a toothbrush doesn't reach. Using a new section of floss allows the plaque to be removed. If the same section is used, the bacteria is redistributed to other areas.

Currently, there are no major options for floss holders.

The standard floss holder is ‘Y' shaped and looks like a slingshot or forked prong device, where the floss is strung taut between the two prongs (there are many variations, see photograph above). The advantage of using a floss holder is the accessibility it affords to otherwise inaccessible areas.The limitation is that the floss cannot wrap around or conform to the tooth. The 'taut' floss can cut the gumline in the front and back of the tooth where it rises.It is cumbersome to 'advance' soiled floss and cannot be used with bridges.It has to be used very carefully.