Please read this Installation guide first, It will save you a lot of time by installing parts in the order designed
Remove
your stock air box, any connecting hoses and air piping.Remove the steel splash shield, and plastic splash shields from both sides underneath the cars engine compartment. You will need to do this for the install.
Remove the Air Conditioning compressor and bracket, all freon lines from compressor to condenser and from compressor to the evaporator. You may remove the condenser for better airflow the radiator sense it has no use.
Remove the exhaust header, shields and header pipe. You will be using the exhaust header down pipe flange that bolts to the cat piping so please save this pipe.
Table of Contents
Click on a page Below
| Installing Turbo | Page 1 |
| Control Box Relocation | Page 2 |
| Installing Turbo Oil Supply Line | Page 3 |
| Installing Wastegate Actuator | Page 4 |
| Installing Charge Pipe Number 2 | Page 5 |
| Installing Charge Pipe Number 3 | Page 6 |
| Installing Vortech 12 to 1 Fuel Management Unit | Page 7 |
| Installing Turbo Oil Drain Line | Page 8 |
| Installing Air Intake Pipe Number 1 | Page 9 |
| Installing Exhaust Header | Page 10 |
| Installing Manual Turbo Boost Controller | Page 11 |
| Installing Blow Off Valve and Boost Guage | Page 12 |
| Installing MSD-Boost Timing Master | Page 13 |
| Installing MAP Check Valve | Page 14 |