Errata: Correction to Haynes manual 3260

  Errata: Correction to Haynes manual 3260[850][95] dave -- Saturday, 17 November 2001, at 4:53 p.m.

     On page 9-4, 1st paragraph (3.):

     "Remove the protective caps over the two caliper guide pins then unscrew
     both pins using a 7 mm hexagonal socket"

     WRONG.

     A 7mm hex socket is utterly useless for this task. What is needed is
     a 7mm hex shaft (iow, allen wrench).

     I guess I shouldn't have expected the Brits to know English (and, after
     all, both words begin with an 's', so this is perfectly understandable...)!

     - Dave; '95 854T, 117K mi
 

Re: Errata: Correction to Haynes manual 3260[850][95]    p.dwyer -- Sunday, 18 November 2001, at 8:39 a.m.

     dave: so IOW, if you follow the manual's directions and only have Sockets, you get the Shaft! In-te-res-ting...VE-ry in-te-res-ting....--PD
 


 
 

back to ozbrick 850 home page
 

If you have any experiences, facts, hints comments or data that you think might be useful on the site, please

email me

and I will post it, with an acknowledgement of your contribution (if you so wish).