This is an
ordinary waterwing for juvelins. There are different sizes, I used
"size 1" but I don't know if it is standardisized
|
I cut the foil at one end
so that both chambers are still joint
directly.
|
Then I glued
both chambers at the boundaries. Now the dildo can be
placed between two chambers filled with water.
|
This is a
detailed view of the entrance. The amount of water has to be
choosen accordingly to the size of the dildo. It schould be fit
in tight. Use lubricant for testing!
|
This is a
detailed view of the entrance.
|
The entance has
rather sharp edges, so an improvement will be to flip
the edges around and glue them.
|
This is a
detailed view of the entrance border
|
THREE CHAMBER VERSION:
I glued three
chambers together and one Zipper at the end
|
This is a detailed view
|
I glued the
zipper at the other side on the other end to close the circle
|
This is the top
view, the zipper is open
|
This is a top
view. Inflated with water
|
Another top view
|